Home arrow Forums



Go Back   XS11.com Forums > Search Forums

Showing results 1 to 25 of 500
Search took 0.28 seconds.
Search: Posts Made By: motoman
Forum: Other Bike Discussion Today, 05:59 PM
Replies: 11
Views: 258
Posted By motoman
Agree......those O-rings and others internally...

Agree......those O-rings and others internally don't agree with a lot of cleaners, specially Berrymans.
Forum: Other Bike Discussion Yesterday, 06:09 PM
Replies: 11
Views: 258
Posted By motoman
Good to hear the Pinesol resolved your issue;).

Good to hear the Pinesol resolved your issue;).
Forum: XS11/XJ11 Discussion Yesterday, 06:05 PM
Replies: 2
Views: 73
Posted By motoman
Yup......pretty much any component related to...

Yup......pretty much any component related to K&L. Definitely don't wanna use any K&L related jets as their numbering crosses over to Genuine Mikuni jets, but their hole sizes are not even close to...
Forum: XS11/XJ11 Discussion 04-20-2018, 10:24 PM
Replies: 11
Views: 192
Posted By motoman
Actually, glazing of one or both pads cause this.

Actually, glazing of one or both pads cause this.
Forum: Wanted to buy - XS and XJ1100 parts and bikes. 04-20-2018, 02:55 PM
Replies: 4
Views: 126
Posted By motoman
Same-same.........and that be 1and3, 2and4.

Same-same.........and that be 1and3, 2and4.
Forum: XS11/XJ11 Discussion 04-19-2018, 11:54 PM
Replies: 10
Views: 177
Posted By motoman
+2 to bikerphil's suggestion and Diver Ray's coil...

+2 to bikerphil's suggestion and Diver Ray's coil reference!
Forum: XS11/XJ11 Discussion 04-19-2018, 07:17 PM
Replies: 10
Views: 177
Posted By motoman
Bike dying and both coils being bad at same...

Bike dying and both coils being bad at same time......highly unlikely. Sounds like a secondary ignition issue somewhere else. May wanna check stop/run switch plug-in under tank on top frame on right...
Forum: XS and XJ 1100 bikes for sale. 04-19-2018, 04:49 PM
Replies: 5
Views: 173
Posted By motoman
With your already known talent Ken, that WILL be...

With your already known talent Ken, that WILL be one sharp dependable XS11! Good to see your still around here occasionally and still have the XS11 interest going!
Forum: XS11/XJ11 Discussion 04-19-2018, 04:05 PM
Replies: 15
Views: 305
Posted By motoman
I believe you have the beginning of the notorious...

I believe you have the beginning of the notorious second gear issue. As those engaging dogs edges get worn somewhat rounded edges, tranny will start popping out of gear under heavy torque loads.
As...
Forum: XS11/XJ11 Discussion 04-18-2018, 12:18 AM
Replies: 15
Views: 305
Posted By motoman
Would first re-adjust the clutch, and that...

Would first re-adjust the clutch, and that adjustment is behind the right side cover plate where clutch cable goes into housing. Aside from that, shifting these ole' tractor trannies smoothly...
Forum: Other Bike Discussion 04-17-2018, 03:59 PM
Replies: 17
Views: 319
Posted By motoman
Cam chain adjustment is done with engine warmed...

Cam chain adjustment is done with engine warmed up first. Engine HAS to be not running for this adjustment and timing pointer on TDC.
Forum: Southwest 04-11-2018, 06:49 PM
Replies: 225
Views: 7,178
Posted By motoman
Hi Ty, if you were planning on attending rally in...

Hi Ty, if you were planning on attending rally in BuennaVita this year, your MOST welcome to stay-over at my and Anita's place. My place to Buenny rally is approx. 3hr. ride along with 3 different...
Forum: XS and XJ 1100 bikes for sale. 04-08-2018, 10:27 PM
Replies: 7
Views: 348
Posted By motoman
......would be a good start:rolleyes::).

......would be a good start:rolleyes::).
Forum: Other Bike Discussion 04-08-2018, 10:25 PM
Replies: 11
Views: 258
Posted By motoman
webbcraft, at this point I suggest you remove all...

webbcraft, at this point I suggest you remove all internal pieces of carbs as possible. Then, since I presume you have an ultrasonic cleaner, buy a jug of the REAL Pine-Sol, no generic. Put that,...
Forum: XS and XJ 1100 bikes for sale. 04-08-2018, 06:08 PM
Replies: 7
Views: 348
Posted By motoman
....lol....and even LESS of the one model year...

....lol....and even LESS of the one model year only 81Venturer 1100.....yea, right:rolleyes:.
Forum: XS11/XJ11 Discussion 04-02-2018, 08:33 PM
Replies: 93
Views: 11,841
Posted By motoman
Vacuum synchronizer Sid. He also needs to insert...

Vacuum synchronizer Sid. He also needs to insert pilot jets into each of the four lines(synchronizer side) in order to remove cyl. pulses so the gauge needles don't flutter like crazy. For future...
Forum: XS11/XJ11 Discussion 03-27-2018, 05:10 PM
Replies: 11
Views: 400
Posted By motoman
Well,...hello ranger. That pretty much leaves...

Well,...hello ranger. That pretty much leaves the obvious at this point.....ignition switch and plug-ins behind fuse panel, or grounding wires...and there are several besides engine/chassis ground...
Forum: XS11/XJ11 Discussion 03-26-2018, 11:27 PM
Replies: 11
Views: 400
Posted By motoman
I'm guessin' that included taking apart the...

I'm guessin' that included taking apart the STOP/RUN switch and cleaning those internal contacts:confused:.
Forum: Southwest 03-25-2018, 05:02 PM
Replies: 225
Views: 7,178
Posted By motoman
BTW, Colo. highway 82 thru Aspen is only some...

BTW, Colo. highway 82 thru Aspen is only some 8-10 blocks long.
Forum: Southwest 03-25-2018, 04:50 PM
Replies: 225
Views: 7,178
Posted By motoman
Very true Jeff......no fix for Aspen. But, for a...

Very true Jeff......no fix for Aspen. But, for a nice lunch stop, the Hickory House at other end of town can't be beat for quality eats and very reasonably priced for you'all. They also have and sell...
Forum: Members Lounge 03-25-2018, 04:33 PM
Replies: 6
Views: 189
Posted By motoman
Have a great Birthday Mike!

Have a great Birthday Mike!
Forum: XS11/XJ11 Discussion 03-24-2018, 09:57 PM
Replies: 2
Views: 273
Posted By motoman
Answer....a bunch, but dealer where I bought mine...

Answer....a bunch, but dealer where I bought mine new(HandleBar Cycle Durango, Colo.) was never able to get another new one in at his dealership as all manufactured had already been sent stateside to...
Forum: Product Evaluations 03-17-2018, 02:52 PM
Replies: 10
Views: 390
Posted By motoman
Excellent choice Kurt;):).

Excellent choice Kurt;):).
Forum: Northeast (and Eastern Canada) 03-14-2018, 08:27 PM
Replies: 20
Views: 776
Posted By motoman
Worked fine Darrell. Am not part of Photo Bucket,...

Worked fine Darrell. Am not part of Photo Bucket, and just using a plain ole' Pentium laptop, no mods, as I'm obviously not 'puter guru.
Forum: Northeast (and Eastern Canada) 03-13-2018, 09:29 PM
Replies: 20
Views: 776
Posted By motoman
Thanks for asking, but no. Only have the jersey...

Thanks for asking, but no. Only have the jersey shirts of those rallies I've attended and or hosted. Only exception has been one from Jeff H. he gave me when I and SWMBO drove to Columbus, Georgia....
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT -6. The time now is 07:26 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2018, jvbPlugin