Thread: Carb parts
View Single Post
  #1  
Old 01-10-2019, 01:54 PM
Aches n Pains's Avatar
Aches n Pains Aches n Pains is offline
XStremely XSive
 
Join Date: Sep 2009
Location: Reston, Va.
Posts: 346
Carb parts

Hi guys,

Restoring an old set of carbs for a friend and he's short a few parts.

1978 E
Need one Diaphragm Assembly (slide, diaphragm and needle)
Need all three plates that bolt to the caps and help hold the carbs together (look like butterflies with four holes) including the one with drop down for the throttle cable

I have a slide and diaphragm from an XS650 (thanks, Donebysunday) but would need the correct needle. Also not sure about the slide as it has two holes in the bottom (one is not open below the slide) and I'm not sure if that effects performance.

Thanks in advance for any help you can give,

Aches n Pains
Doug
__________________
1995 KZ100P
Pods, jets, pipes, cam adjuster, oil cooler

1977 Ironhead - custom build
Hot engine, custom frame, KZ front and rear, high torque starter, alternator conversion, Progressive shocks, Thunderheart wiring, Dyna ignition, oil cooler, Dakota Digital instruments, etc.

Sold all my XS's to Eastcoaster but still love to keep up with you guys. This is the best cycle forum on the web.
Reply With Quote