View Single Post
  #1  
Old 08-23-2011, 09:33 PM
Cobia's Avatar
Cobia Cobia is offline
XS-XJ Guru
 
Join Date: Jul 2007
Location: Palm Beach County, Fl
Posts: 1,587
Eliminate Sqeaky Brakes.

As part my rebuild I installed new EBS copper sintered brake pads on my G.
After a while they started squeaking, no - more like squealing like pigs!!
Every time I pulled up to a light, I got stares. And when riding with others.... the comments were always forthcoming.
I sanded the rotors to no avail. So I tried a trick I used to employ on my VWs and Volvos.
I removed the calipers and pads, sanded the rotors with 80 grit, and then I grooved the pads. I grooved the pads by putting them in a vice, lengthwise, then using a hacksaw I cut a perpendicular groove leaving aout 1/8" of backing. This creates two +/- 1.25" X 1.25" pads on the metal backing.
I then applied some of that 'special' brakepad grease on the backs of the pads, re-installed them, and re-assembled the calipers.
Haven't heard a squeak or squeal since.
Hope this helps if you're experiencing the same issue.
__________________
1980G Standard, Restored
Kerker 4 - 1
850 Rear End Mod
2-21 Flashing LED Arrays on either side of license plate for Brake Light Assist, 1100 Lumen Cree Aux Lights,
Progressive springs, Showa rear shocks
Automatic CCT
1980GH Special, Restored
Stock Exhaust, New Handlebars, 1" Spacer in Fork Springs, Automatic CCT, Showa Rear Shocks
'82 XJ1100 (Sold)
Automatic CCT, RC Engineering 4 X 1 Exhaust, K&N Pods, #50 Pilot Jets, YICS Eliminator. Sorely missed.

Last edited by crazy steve; 05-20-2013 at 12:08 PM.