View Single Post
  #43  
Old 10-25-2017, 05:12 PM
motoman motoman is offline
Master of XSology
 
Join Date: Aug 2005
Location: Grand Junction, Colorado
Posts: 8,214
Quote:
Originally Posted by darylcaribou69 View Post
I did replace the o rings with 3mm inside diameter by 1mm cross section o rings. I read somewhere that those are the ones it needs. Probably not though.
Obviously have previously replaced mine with similar issue, but they were sent to me IIRC from Yamaholic. So consequently, have no knowledge of their actual size, but highly suspect based on my own experience that is the first suspect issue. After putting new 0rings on those mixture screws, smear just a shiny coating of dielectic grease on them. This keeps them from being pinched or distorted when screwing them back in carb.
__________________
81H Venturer1100 "The Bentley" (on steroids) 97 Yamaha YZ250(age reducer) 92 Honda ST1100 "Twisty"(touring rocket) Age is relative to the number of seconds counted 'airing' out an 85ft. table-top.
Reply With Quote