#1
|
|||
|
|||
Is your Bell Qualifier helmet too tight?
I replaced my cheek pads with a smaller size. Which means I have unused 35mm pads for anyone who might need them. I needed 30mm.
They snap right in. Or if any of you regularly go to swap meets and can give them away... I hate sending useful stuff to a landfill! Yours for postage.
__________________
Steve R '80 SG "Fred" -- TC fuse box, stock airbox/exhaust/jets, SS brake lines, Windjammer V fairing, Cibie headlight lens, TKAT fork brace, Showa rear shocks, MikesXS emulators Former bikes: 1973 Yamaha 125 Enduro (brother's but I 'borrowed' it a lot, usually after midnight) 1978 XS400E Red 1981 XS850 Special (Stingo) |
#2
|
||||
|
||||
I'm interested in having fresh pads to keep it a snug fit.
Are you going to XSSE? I could pick up there if not too much trouble to bring with you. Brian
__________________
'78 XS1100E (the newest bike I've ever owned) '74 CB350F1 (under restoration) '72 RT2 MX360 (the "Yak" gone but not forgotten, she was my first, after all) |
#3
|
|||
|
|||
Hey Brian—I am hoping to visit my family in GA around that time and was thinking I would stop by, but it’s only about a 50-50 chance at this point. Pm me your address and I’ll send them your way, postage on me.
__________________
Steve R '80 SG "Fred" -- TC fuse box, stock airbox/exhaust/jets, SS brake lines, Windjammer V fairing, Cibie headlight lens, TKAT fork brace, Showa rear shocks, MikesXS emulators Former bikes: 1973 Yamaha 125 Enduro (brother's but I 'borrowed' it a lot, usually after midnight) 1978 XS400E Red 1981 XS850 Special (Stingo) |
![]() |
Thread Tools | |
Display Modes | |
|
|