Home arrow Forums

Go Back   XS11.com Forums > Modifications > Transmission

Thread Tools Display Modes
Old 06-20-2002, 12:35 PM
xs11 xs11 is offline
Super Moderator
Join Date: Jun 2002
Posts: 130
Barnett Clutch Problems

Barnett Clutch Problems

David R. Norton

From all that has been posted regarding Barnett clutches, it seems that there are a lot of problems with them. Are these the standard clutches, Kevlar clutches, or other? Also, what specifically are the problems?
The problems I've had with Barnett clutches go all the way back into the 1950s with Triumph motorcycles and continue still!

Problem? The clutch plates aren't flat. There's only a limited amount of travel in a motorcycle clutch throwout mechanism and if the plates are warped some of that travel is spent in moving past the warpage. Result is the clutch just can't be adjusted properly, it either drags (won't fully release) or slips (won't engage fully).

If you have these problems with a Barnett clutch, just remove the plates, stack all the friction plates (in a multi-plate clutch) in a pile and see that they don't sit flat against each other. Now do the same with the steel plates, same problem. Now compare with the factory plates, they will sit flat. A single plate clutch can be checked by sitting it on a flat surface, the last Barnett I pulled out of a Triumph Trident and trashed had about a .020" dish in it, the Trident allowed only .040" of clutch throwout movement! With a factory clutch all the problems vanished.

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump

All times are GMT -6. The time now is 02:32 AM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2022, jvbPlugin