Home arrow Forums



Go Back   XS11.com Forums > Modifications > Carburetors & Fuel System

 
 
Thread Tools Display Modes
  #1  
Old 06-11-2011, 09:50 PM
crazy steve crazy steve is offline
XS-XJ Guru MODERATOR
 
Join Date: Jan 2009
Location: Beautiful outer Yelm, WA
Posts: 7,932
Special Petcock Mod

Ok, you've eliminated the octy and now have two 'extra' fuel line connections; what to do? Some just loop a length of fuel hose between them, some use two short pieces of hose and plug them with a bolt or something, some fill them with some sort of goo. Here's a bit more elegant solution, and likely cheaper too!



This will convert your petcock to full manual, and eliminate the 'prime' position (converting it to another 'off'), as well as sealing it. Simply run a 5m/.8 pitch tap into the 'prime' feed hole as shown (you don't even need to drill; it's big enough), then thread a same-size set screw into it. I used a 10mm long screw, but a 5mm would be better and don't run the tap in as far as I did. Thread it just deep enough so that the screw goes in flush. I put some teflon tape on, and it's sealed. If you want to reinstall the octy, just pull the screw.

The optional 1/4" ID rubber cap is just for 'finish' and to keep the spigot clean for future; gas won't get to it. The screws were only $.75 for both.

This could also be done to the standard petcock (with a larger screw), but would require other internal mods. And if you want to replace those always-rusty small screws that hold on the chrome cover, run a 6-32 tap through the holes and use some stainless buttonheads. Again, you don't even need to drill (but you do need to enlarge the holes on the cover), just run the tap through. You can do this to either type petcock...
__________________
Fast, Cheap, Reliable... Pick any two

'78E original owner - resto project
'78E ???? owner - Modder project FJ forks, 4-piston calipers F/R, 160/80-16 rear tire
'82 XJ rebuild project
'80SG restified, red SOLD
'79F parts...
'81H more parts...

Other current bikes:
'93 XL1200 Anniversary Sportster 85RWHP
'86 XL883/1200 Chopper
'82 XL1000 w/1450cc Buell, Baker 6-speed, in-progress project
Cage: '13 Mustang GT/CS with a few 'custom' touches
Yep, can't leave nuthin' alone...

Last edited by crazy steve; 12-26-2012 at 07:17 PM.
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Forum Jump


All times are GMT -6. The time now is 01:20 PM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2017, jvbPlugin