Home arrow Forums

Go Back   XS11.com Forums > Idle Talk Forum > XS11/XJ11 Discussion

Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-31-2016, 06:13 AM
BillyRok BillyRok is offline
XStremely XSive
Join Date: Aug 2011
Location: Shortsville, NY.
Posts: 411
Dented Exhaust Header

I have a dent in the bottom bend of #1 exhaust header and am looking for suggestions as to how I could remove it.



How about this...I was considering filling the bend with water and then letting it pipes sit outside for a while in the below freezing temps and see if the dent would pop out as the water expands when freezing. Thinking about the double wall tubing construction, I would want water in both tubes. How far down the header does the double wall go? I'm thinking I can pour water in the header where it bolts to the motor to fill the inner tube and then remove the bolt in the bottom of the pipe just ahead of the heat shield and add water to fill the outer tube.

You guys think this might work without rupturing the pipe? Or anybody have other proven solutions or reasonable ideas? Thanks much.

1982 XJ1100, Ceramic Coated Headers, Raptor ACCT, Barnett Clutch Springs, Dremmel Fix, TC's Fuse Block, De-Linked S/S Brake Lines, 850 Final Drive, Yahman's YICS Eliminator, Pods, stock jets
Reply With Quote

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

All times are GMT -6. The time now is 06:51 PM.

Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2022, Jelsoft Enterprises Ltd.
Integrated by BBpixel ©2004-2022, jvbPlugin